HP MSR SERIES Configuration Manual page 287

5. Enable Agent to send SNMP traps:
a. Click the Trap tab and perform the following configuration as shown in
b. Select the Enable SNMP Trap box.
c. Click Apply.
Figure 279 Adding target hosts of SNMP traps
6. Add target hosts of SNMP traps:
a. On the Trap tab page, click Add and perform the following configuration as shown in
280.
b. Select the destination IP address type as IPv4/Domain.
c. Type the destination address 1.1.1.2.
Type the user name user1.
d.
e. Select v3 from the Security Model list.
f. Select Auth/Priv from the Security Level list.
g. Click Apply.
Figure 280 Adding target hosts of SNMP traps
270
Figure 279.
Figure