Wireless Qos Configuration Example; Cac Service Configuration Example - HP MSR SERIES Configuration Manual

Table 76 Configuration items
Item
Wireless Service
Direction
Mode
Rate

Wireless QoS configuration example

CAC service configuration example

Network requirements
As shown in
and AC-VI queues of the clients of the fat AP. Use the user number-based admission policy to limit the
number of access users to 10, so that the clients using high-priority queues (including the AC-VO and
AC-VI queues) can be guaranteed of enough bandwidth.
Figure 122 Network diagram
Configuration procedure
1. Configure the access service:
For related configurations, see
follow the steps in the related configuration example to configure the wireless service.
2. Configure wireless QoS:
a. Select Interface Setup > Wireless > Wireless QoS from the navigation tree.
b. Click the QoS Service tab. Make sure WMM is enabled.
Figure 122, an AP with WMM enabled accesses the Ethernet. Enable CAC for the AC-VO
Description
Existing wireless service.
Inbound or outbound.
•
Inbound—From clients to the device.
•
Outbound—From the device to clients.
•
Both—Includes inbound (from clients to the device) and outbound
(from the device to clients).
Rate limiting mode, dynamic or static.
•
Dynamic mode.
•
Static mode.
Set the rate of the clients.
•
If you select the static mode, static rate is displayed, and the rate is
the bandwidth of each client.
•
If you select the dynamic mode, share rate is displayed, and the rate
is the total bandwidth of all clients.
"Wireless access service configuration
127
examples." You can strictly