Honda 1998 VT750C Service Manual page 325

REAR WHEEL/BRAKE/SUSPENSION
Apply grease to the brake cam sliding surface.
Install the brake cam into the brake panel.
Apply oil to the felt seal and install it onto the brake
panel.
Install the wear indicator plate on the brake cam
aligning its wide tooth with the wide groove on the
brake cam.
Install the brake arm aligning the punch marks of
the arm and the brake cam.
Install and tighten the brake arm pinch bolt to the
specified torque.
TOROUE: 29 N·m (3.0 kgf·m, 22 Ibt-ft)
BRAKE CAM
PLATE
BRAKE CAM
BRAKE ARM
14-14
Apply grease to the brake shoe-to-cam sliding BRAKE SHOES
surface.
Apply grease to the anchor pin sliding surfaces.
Install the brake shoes and springs.
SPRINGS
,
"
,
'-,
,,~
-~