Honda 1998 VT750C Service Manual page 140

7. ENGINE REMOVAL/INSTALLATION
SERVICE INFORMATION
DRIVE SPROCKET REMOVAL
ENGINE REMOVAL
SERVICE INFORMATION
GENERAL
7-2
7-3
7-5
ENGINE INSTALLATION 7-9
DRIVE SPROCKET INSTALLATION 7-13
)
• A floor jack or other adjustable support is required to support and maneuver the engine.
CAUTION:
Do not support the engine using the oil filter.
• When removing/installing the engine, tape the frame around the engine beforehand for fame protection.
• The following components can be serviced with the engine installed in the frame.
- Alternator (Section 9)
- Camshaft (Section 10)
- Carburetor (Section 5)
- Clutch/gearshift linkage (Section 8)
- Front cylinder (Section 11)
- Front cylinder head (Section 10)
-Ignition pulse generator (Section 17)
- Starter motor/starter clutch (Section
18)
• The following components require engine removal for service.
- Cylinder/piston (Section 11)
- Crankshaft (Section 12)
- Oil pump (Section 4)
- Rear cylinder (Section 11)
- Rear cylinder head (Section 10)
- Shift fork, shift drum and shift spindle (Section 12)
- Transmission (Section 12)
- Water pump body (Section 6)
• After engine installation, adjust the following.
- Clutch cable (page
3-26)
- Drive chain (page
3-18)
- Throttle cable (page 3-4)
7-1