Honda 1998 VT750C Service Manual page 150

ENGINE REMOVAL/INSTALLATION
Route the neutral switch and oil pressure switch wire
harness properly (refer to section 2).
Clean and apply a locking agent to the countershaft
set plate bolt threads.
Install the countershaft oil seal set plate then tighten
the mounting bolts securely.
Install the drive chain guide plate then tighten the
mounting bolts to the specified torque.
TORQUE: 12 N·m (1.2 kgf·m, 9Ibf·ft)
Install the cord clam per then tighten the mounting
bolts securely.
BOLTS
BOLT
CLAMPER
GUIDE PLATE
II
SET PLATE
Connect the neutral switch and oil pressure switch CLAMPERS
cord terminal.
Install and tighten the oil pressure switch terminal
screw to the specified torque.
TORQUE: 2 N·m (0.2 kgf·m, 1.4 Ibf·ft)
I
OIL PRESSURE SWITCH
Connect the spark plug caps.
Install the following:
- Drive sprocket (see below)
- Right footpeg and rear brake pedal (page 14-16)
- Exhaust pipe/muffler (page 2-8)
- Sub-air cleaner housing (page 10-35)
- Carburetor (page 5-20)
- Air cleaner chamber (page 5-7)
- Air cleaner housing (page 5-4)
- Steering cover (page 2-3)
- Fuel tank (page 2-4)
Fill the engine oil (page 3-12)
Fill and breed the cooling system (page 6-5).
Connect the battery negative cable to the battery
terminal.
7-11