Honda 1998 VT750C Service Manual page 149

ENGINE REMOVAL/INSTALLATION
Route the alternator wire harness properly (refer to
section 2).
Connect the alternator wire 3P (White) connector.
Route the ignition pulse generator wire harness
properly (refer to section 2).
Connect the ignition pulse generator wire 2P (White)
connector.
Connect the clutch cable to the clutch lifter arm.
Install the clutch cable holder and bolt.
Tighten the holder bolt securely.
Connect the starter motor cable and ground cable
to the starter motor.
Install and tighten the cable nut to the specified
torque.
TORQUE: 10 Nom (1.0 kgf·m, 7 Ibf·ft)
7-10
CLUTCH CABLE HOLDER
,
....
CLUTCH CABLE
GROUND CABLE