Honda 1998 VT750C Service Manual page 419

LIGHTS/METERS/SWITCHES
REMOVAL
Remove the right side cover (page 2-4).
Disconnect the side stand 3P (Green) connector.
Remove the side stand switch bolt and side stand
switch.
INSTALLATION
Install the side stand switch.
NOTE:
• During side stand switch installation, align the pin
on the switch with the hole in the side stand.
During side stand switch installation, align the
groove on the switch with the pin on the side
stand bracket.
SIDE STAND SWITCH
Install and tighten the new side stand switch bolt to
the specified torque.
TORQUE: 10 N·m (1.0 kgf·m, 7 Ibf·ft)
NOTE:
Route the side stand switch wire properly (page 1-
27) .
Connect the side stand switch 3P (Green) connector.
Install the right side cover (page 2-4).
19-24
~
SBOLT
SIDE STAND SWITCH