Honda 1998 VT750C Service Manual page 220

Install the dowel pins.
Lubricate each rocker arm slipper surfaces with
molybdenum disulfide oil.
NOTE:
Before camshaft holder installation, loosen the valve
adjusting screw and lock nut fully.
Install the camshaft holder assembly.
CYLINDER HEAD/VALVES
DOWEL PINS
\
CAMSHAFT HOLDER
Install the oil guide plate. NUT
Install the camshaft holder bolts (8 mm), nuts and
washer (8 mm).
Tighten the bolts (8 mm) and nuts (8 mm) to the
specified torque.
TORQUE: 8 mm bolt: 23 N'm (2.3 kgf'm, 17 IbMt)
8 mm nut: 23 N'm (2.3 kgf'm, 17 Ibf·ft)
CAMSHAFT HOLDER
NUT/WASHER
Be careful not to let
the cam sprocket
bolts fall into the
crankcase.
Install the cam sprocket on the camshaft flange and
recheck that the timing marks align with the upper
surface of the cylinder head.
Clean and apply a locking agent to the cam sprocket
bolt threads.
Align the cam sprocket bolt holes in the cam
sprocket and camshaft.
Temporarily install the cam sprocket bolt.
Turn the crankshaft counterclockwise 360' and
tighten other sprocket bolt to the specified torque.
TORQUE: 23 N'm (2.3 kgf'm, 17 Ibf·ft)
10-31