Honda 1998 VT750C Service Manual page 389

ELECTRIC STARTER
Install the new O-ring.
Install the same number of shims in the same
locations as when disassembled.
Install the washer and terminal nut.
Tighten the terminal nut securely.
~., O-RING
IlIiiiIjl'
WASHER
~(
SHIMS
NUT~
NUT
Push and hold the brush inside the brush holder, BRUSH SPRINGS
and install the armature through the brush holder.
When installing the armature into the stater motor
case, hold the armature tightly to keep the magnet
from pulling the armature against the stater motor
case.
CAUTION:
• The coil may be damaged if the magnet pulls the
armature against the case.
• The sliding surfaces of the brushes can be
damaged if they are not installed properly.
Set the brush springs.
Install the same number of thrust washers in the
same locations as when disassembled.
ARMATURE
18-10
WASHERS