Electric Starter - Honda 1998 VT750C Service Manual

18. ELECTRIC STARTER
SYSTEM DIAGRAM
SERVICE INFORMATION
TROUBLESHOOTING
SERVICE INFORMATION
18-0
18-1
18-2
STARTER MOTOR
STARTER RELAY SWITCH
CLUTCH DIODE
18-4
18-13
18-14
GENERAL
mI!III'-- _
Always turn the ignition switch OFF before servicing the starter motor. The motor could suddenly start, causing serious
injury.
o When checking the starter system, always follow the steps in the troubleshooting flow chart (page 18-2).
A weak battery may be unable to turn the starter motor quickly enough, or supply adequate ignition current.
If current continues to flow kept flowing through the starter motor while the engine is not cranking over, the starter
motor may be damaged.
Always turn of the ignition switch before disconnecting any electrical components.
For following components inspections, refer to the following pages, for the parts locations, see page 18-0 of this manu-
al.
- Side stand switch (Section 19)
- Neutral switch (Section 19)
-Ignition switch (Section 19)
- Starter switch (Section 19)
- Clutch switch (Section 19)
SPECIFICATIONS
Unit: mm (in)
ITEM STANDARD SERVICE LIMIT
Starter motor brush length
12.5 (0.49)
6.5 (0.26)
TORQUE VALUES
Starter motor cable nut
10 Nom (1.0 kgfom, 7 Ibfoft)
18-1