Oil Pressure Switch; Wire Harness Inspection - Honda 1998 VT750C Service Manual

LIGHTS/METERS/SWITCHES
WIRE HARNESS INSPECTION
Disconnect the speed sensor 3P connector.
Check the continuity between Green/Black terminal
of 3P connector wire harness side and ground.
Turn the ignition switch ON.
Measure the voltage at the 3P connector wire
harness side.
CONNECTION: Black/Brown 1+) - ground 1-)
STANDARD: Battery voltage
If the measured value is out of specification, check
for continuity of the Pink wire between the
speedometer 9P (Black) connector and speed sensor
3P (White) connector.
3P CONNECTOR •
.~~~---
3P (WHITE) CONNECTOR
STANDARD: Continuity
If the measured value is out of specification, inspect
the wire harness.
OIL PRESSURE SWITCH
NOTE:
The oil pressure switch removal/installation
procedure is on page 4-3.
Make sure that the oil pressure warning indicator
comes on with the ignition switch "ON".
19-14
00
VT750C:
VT750CD/CD2
('98 - 2000) :
OIL PRESSURE.
INDICATOR
9P (BLACK) CONNECTOR