Honda 1998 VT750C Service Manual page 222

Clean the gasket groove and cylinder head mating
surface of the cylinder head cover.
Apply Honda Bond A or equivalent to the gasket
groove of the cylinder head cover.
Install the gasket into the groove.
Clean the cylinder head cover mating surface of the
cylinder head.
Install the front cylinder head cover to the front cylin-
der.
Apply engine oil to the rubber seals whole surface.
Install the rubber seals and washers.
Install and tighten the cylinder head cover bolts to
the specified torque.
TORQUE: 10 Nom 11.0 kgfom, 7 Ibfoft)
Install the thermostat housing to the frame.
Install and tighten the mounting bolt with the ground
cable.
CYLINDER HEAD/VALVES
HONDA BOND A
HEAD COVER
10-33