Oil Filter Change - Honda 1998 VT750C Service Manual

MAINTENANCE
Fill the crankcase with the recommended engine oil.
Oil CAPACITY:
2.2 liter (2.32 US
qt.
1.94 Imp qt) at draining
2.9 liter (3.06 US qt, 2.55 Imp qt) at disassembly
2.4 liter (2.54 US qt, 2.11 Imp qt) at oil filter
change
Install the oil filter cap/dipstick.
Start the engine and let it idle for 2 or 3 minutes.
Stop the engine and weight a few minutes, then
check that the oil level is at the upper level mark
with the motorcycle upright.
Check that there are no oil leaks.
Drain the engine oil (page 3-12).
Remove the oil filter using the oil filter wrench.
Apply oil to the new oil filter a-ring.
07HAA-PJ70100
• If the engine must be running
to
do some work,
make sure the area is well-ventilated. Never run
the engine in an enclosed area. The exhaust con-
tains poisonous carbon monoxide gas that may
cause loss of consciousness and may lead to
death.
• Engine and exhaust system parts become very
hot and remain hot for sometime after the engine
is run. Wear insulated gloves or wait until the
engine is run. Wear insulated gloves or wait until
the engine and exhaust system have cooled
before handling these parts.
Apply oil to the new oil filter threads.
Install and tighten the new oil filter to the specified
torque.
TOOL:
Oil filter wrench
OIL FILTER CHANGE
!i!lll!L-- _
TORQUE: 10 N'm (1.0 kgf'm, 7 Ibfoft)
Fill the crankcase with the recommended engine oil
(page 3-12).
Install the oil filler cap/dipstick.
Start the engine and recheck the oil level (page 3-
13).
Make sure that there are no oil leaks.
OIL FILTER
~~~
__iii' .
III
a-RING
3-13