Honda 1998 VT750C Service Manual page 164

CLUTCH/GEARSHIFT LINKAGE
INSPECTION
PRIMARY DRIVE GEAR
SUB-GEAR
Check the serrated teeth of the primary
drive
gear for
wear or damage.
Check the serrated teeth of the sub-gear for wear or
damage.
Check the primary
drive
gear spring and friction
spring for fatigue or damage.
SPRINGS
FRICTION SPRING
INSTALLATION
Align the three
Assemble the primary
drive
gear, primary
drive
gear
holes on the
spring, friction spring and sub-gear as shown.
sub-gear and
primary drive
gear.
PRIMARY DRIVE GEAR
SUB-GEAR
HOLES
PRIMARY DRIVE GEAR
SPRING
FRICTION SPRING
The primary drive
Install the primary
drive
gear assembly with the sub-
gear will only go
gear side facing out.
on in one position
because of the
extra wide
aligning spline.
ALIGN
8-11
IGNITION PULSE GENERATOR
ROTOR
Apply engine oil to the primary drive gear bolt
threads and seating surface.
Install the washer and primary
drive
gear bolt.
Install the ignition pulse generator rotor.
The ignition pulse
generator rotor
will only go on in
one position
because of the
extra wide
aligning spline.