FUEL SYSTEM
FUEL PUMP
ml!llll!L--
_
Gasoline is extremely flammable and is explosive
under certain conditions. KEEP OUT OF REACH OF
CHILDREN.
SYSTEM INSPECTION
Remove the right side cover (page 2-4).
Turn the ignition switch OFF.
Disconnect the fuel cut relay 3P connector and
connect the voltmeter at the 3P connector wire
harness side.
CONNECTION: Black
(+) -
body ground (-)
Turn the ignition switch ON.
There should be battery voltage.
If there is no voltage, check for an open circuit or
loose connection in Black wire.
If there is battery voltage, check for continuity in the
Black/Blue wire.
Check for continuity between the Black/Blue wire
and ground at the 3P connector wire harness side.
CONNECTION: Black/Bliue - body ground
STANDARD:
No continuity
If there is continuity, replace the fuel cut relay.
If there is no continuity, short the terminals of the
3P connector wire harness side with the suitable
jumper wire.
SHORT TERMINALS: Black/Blue - Black
5-24