Honda 1998 VT750C Service Manual page 212

Install the spring seats and new stem seals.
Lubricate each valve stems and valve guide inner sur-
faces with molybdenum disulfide oil.
Install the valves into the valve guides.
NOTE:
To avoid damage to the stem seal, turn the valve
slowly when valve installing.
Install the valve spring with tightly would coils side
facing the combustion chamber.
CYLINDER HEAD/VALVES
VALVE SPRING
Compressing the valve springs more than neces-
sary will cause loss of
valve spring tension.
Install the retainers.
Install the valve spring compressor onto the valve
and compress the valve springs.
TOOL:
Valve spring compressor
CAUTION:
07757-0010000 or
07957-3290001
VALVE SPRING COMPRESSOR -
To ease installation Install the valve cotters.
of the cotters,
grease them first. NOTE:
- - - - - - - - - - - - - - - - - - -
Support the cylinder head so that the valve heads
will not contact anything that causes damage.
Set the cotters firmly using two soft hammers as
shown. Hold one hammer on the valve stem and
gently tap it with the other hammer.
10-23