Battery - Honda 1998 VT750C Service Manual

BATTERY
Always turn the
ignition switch OFF
before removing or
installing the
battery.
REMOVAL
Remove the seat (page 2-2).
Remove the ignition control module from the battery
case cover.
Remove the three screws and battery case cover.
Disconnect the battery negative cable first, then
positive cable from the battery.
Remove the bolt and battery negative cable.
Remove the positive cable cover.
Remove the bolt and battery positive cable.
Pull the battery out of the battery case.
INSTALLATION
Place the battery into the case and connect the
battery positive cable to the battery first from the
left side, then connect the negative cable from the
right side.
Coat the battery terminal with clean grease.
Install the battery case cover then tighten the three
screws to the specified torque.
TORQUE:
10
N·m
(1.0
kgf.m, 7 Ibf·ft)
Install the ignition control module to the battery case
cover.
Install the seat (page 2-2).
INSPECTION
Measure the battery voltage using a commercially
available digital multimeter.
VOLTAGE: Fully charged: 13.0 - 13.2 V
Under charged: Below 12.3 V
SATTERY/CHARGING SYSTEM
BATTERY
.-
BATTERY
16-5