Honda 1998 VT750C Service Manual page 276

FRONT WHEEL/SUSPENSION/STEERING
Install the attaching screws and tighten the forward
screw first, then tighten the rear screw to the
specified torque.
TORQUE: 3 N·m (0.3 kgf·m, 2.2 Ibf·ft)
Install the master cylinder and holder with the
"UP"mark facing up.
Align the end of the master cylinder with the punch
mark on the handlebar and tighten the upper bolt
first, then tighten the lower bolt to the specified
torque.
TORQUE: 12 N·m (1.2 kgf·m, 9Ibf·ft)
Connect the front brake light switch connector to
the switch.
MASTER CYLINDER
_\
HOLDER
BOLTS
Install the adapter and left handlebar grip onto the HANDLEBAR GRIP
handlebar (refer to page 13-5).
ADAPTER
Install the left handlebar switch housing onto the
handlebar by aligning the locating pin with the hole
in the handlebar.
13-11