Honda 1998 VT750C Service Manual page 355

RETAINER
/
.,.
DusTsEALS
I
PISTONS
~BOOT
til
PISTON SEALS
Install the pad spring into the caliper body.
Replace the bracket pin boot with a new one if it is
worn, deteriorated or damaged.
Coat new piston seals with clean brake fluid and
install them in the seal grooves in the caliper.
Coat new dust seals with silicone grease and install
them in the seal grooves in the caliper.
Coat the caliper piston with clean brake fluid and
install it into the caliper cylinder with the opening
toward the pads.
• Replace the dust seals and piston seals with new
ones.
• Replace the caliper and bracket pin boots there is
wear, deterioration or damage.
• Apply silicone grease to the boot inner surface.
• Be sure that each part is free from dust or dirt
before reassembly.
Install the bracket pin boot to the caliper body.
NOTE:
HYDRAULIC BRAKE
Replace the caliper pin boot with a new one if it is
worn, deteriorated or damaged.
Install the caliper pin boot.
Apply Threebond #1521 or equivalent to the pad
retainer-to-caliper bracket seating surface.
Install the pad retainer to the caliper bracket.
VT750Cand
Install the speedometer cable guide to the caliper
VT750COIC02
bracket.
('98 - 2000):
RETAINER
\.
\
~BOOT
CABLE GUIDE
(VT750C,
VT750CD/CD2 ('98 - 2000) :)
o
BRACKET
Apply silicone grease to the caliper and bracket pins.
Install the caliper bracket over the caliper.
CALIPER BODY
\
15-16