Rear Cylinder Camshaft Service Only (Front Cylinder Camshaft Was Not Serviced); Front Cylinder Camshaft Service Only (Rear Cylinder Camshaft Was Not Serviced) - Honda 1998 VT750C Service Manual

Then turn the crankshaft counterclockwise 232
0
and
align the "RT" mark on the flywheel with the index
mark on the left crankcase cover, then install the
rear camshaft (see below).
REAR CYLINDER CAMSHAFT SERVICE ONLY (FRONT
CYLINDER CAMSHAFT WAS NOT SERVICED)
If the front cylinder head was not serviced, remove
the front cylinder head cover (page 10-5) and check
the camshaft position as follows:
Remove the front cylinder head camshaft end holder
(page 10-8).
Remove the timing hole cap.
Turn the crankshaft counterclockwise and align the
"FT" mark on the flywheel with the index mark on
the left crankcase cover, then check that the
camshaft "TDC (Top Dead Center)" mark is facing
up.
If the "TDC (Top Dead Center)" mark is facing up,
turn the crankshaft counterclockwise 308 0 and align
the "RT" mark on the flywheel with the index mark
on the left crankcase cover, then install the rear
camshaft (page 10-30).
If the "TDC (Top Dead Center)" mark is facing down,
turn the crankshaft counterclockwise 668
0
(360
0
+308
0
)
and align the "RT" mark on the flywheel with the
index mark on the left crankcase cover, then install
the rear camshaft (page 10-30).
FRONT CYLINDER CAMSHAFT SERVICE ONLY
(REAR CYLINDER CAMSHAFT WAS NOT SERVICED)
If the front cylinder head was not serviced, remove
the rear cylinder head cover (page 10-6) and check
the camshaft position as follows:
Remove the front cylinder head camshaft end holder
(page 10-8),
Remove the timing hole cap.
Turn the crankshaft counterclockwise and align the
"RT" mark o'n the flywheel with the index mark on
the left crankcase cover, then check that the
camshaft "TDC (Top Dead Center)" mark is facing
up.
CYLINDER HEAD/VALVES
"RT" MARK
.......~~-~""""'I"FT"
MARK
"RT" MARK
"RT" MARK
10-29