Cylinder Head Installation - Honda 1998 VT750C Service Manual

CYLINDER HEAD/VALVES
CYLINDER HEAD INSTALLATION
NOTE:
• The front cylinder head service using the same
procedure as for the rear cylinder head.
• Be careful not to damage the mating surfaces
when cleaning the cylinder mating surface.
• When cleaning the cylinder mating surface,
place the shop towel over the cylinder opening
to prevent dust or dirt from entering the engine.
Clean any gasket material from the cylinder mating
surfaces.
Install the cam chain guide by aligning its tab with
the groove on the cylinder.
Make sure that the end of the guide is inserted into
place in the crankcase.
Install the dowel pins and new gasket.
CHAIN GUIDE
Install the insulator, aligning the boss on the cylinder
head with the slot in the insulator as shown.
Install the insulator bands and tighten the screws
securely.
10-24
SCREW
INSULATOR