SSANGYONG 1999 Musso Service Manual page 110

6. Remove the guide rail fixing pin from the cylinder head using
the sliding hammer (01) and the threaded pin (02).
7. Remove the cylinder head bolts in numerical order.
Installation Notice
Tightening Torque
8. Check the length of the cylinder head bolt.
Installation Notice
Length (L)
Replace the bolt if the measured length exceed the
max. length.
Apply the oil to the thread surface of bolt.
9. Carefully remove the cylinder head and check the mating
surface.
10. Installation should follow the removal procedure in the
reverse order.
Sliding Hammer 116 589 20 33 00
Threaded Pin 116 589 02 34 00
1st step 55 Nm
2nd step 90°
3rd step 90°
Box Wrench Insert 000 589 01 10 00
New 160 ± 0.8 mm
Max. 162 ± 0.7 mm
M162 ENGINE MECHANICAL 1B1-37