Removing The Rear Alignment Motor - Canon Finisher-AK1 Service Manual

4
Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Rear Alignment Motor > Procedure
5) Remove the Front Alignment Motor [1].
• 1 Wire Saddle [2]
• 1 Connector [3]
• 2 Screws [4]
[3]
[2]
[1]
x2
4 Parts Replacing and Cleaning > Intermediate Process Tray Assembly > Removing the Rear Alignment Motor > Procedure
[4]
F-4-178

Removing the Rear Alignment Motor

■ Preparation
1) Remove the Stack Wall (Lower).(Refer to page 4-29)
2) Remove the Stack Wall (Upper).(Refer to page 4-27)
3) Remove the Neat Stack Unit (Lower).(Refer to page 4-59)
4) Remove the Process Tray Unit.(Refer to page 4-62)
5) Remove the Process Tray (Front).(Refer to page 4-68)
6) Remove the Stack Delivery Motor.(Refer to page 4-72)
7) Remove the Process Tray Plate Unit.(Refer to page 4-72)
■ Procedure
CAUTION:
When replacing or installing/removing the Rear Alignment Motor, be sure to perform the
following adjustment.
• Adjusting Right Angle of the Alignment Plate (Refer to page 4-77)
• Adjusting the Alignment Plate Width (Refer to page 5-26)
4-75
4-75