Door Lock Knob Switch Test
Driver's Door
1. Remove the driver's door panel (see page 20-7).
2. Disconnect the 3P connector (A) from the actuator
(B).
B
3. Check for continuity between the No. 1 and No. 2
terminals in each switch position.
• There should be continuity with the knob switch
in LOCK.
• There should be no continuity with the knob
switch in UNLOCK.
4. Check for continuity between the No. 2 and No. 3
terminals in each switch position.
• There should be continuity with the knob switch
in UNLOCK.
• There should be no continuity with the knob
switch in LOCK.
5. If the continuity is not as specified, replace the
switch.
Passenger's Door (With Security System)
1. Remove the front passenger's door panel (see page
20-7).
2. Disconnect the 3P connector (A) from the actuator
(B).
A
3. Check for continuity between the No. 1 and No. 2
terminals in each switch position.
• There should be continuity with the knob switch
in UNLOCK.
• There should be no continuity with the knob
switch in LOCK.
4. If the continuity is not as specified, replace the
switch.
A
B
(cont'd)
22-281