Driver's Window Motor Test - Honda 2004 Odyssey Service Manual

Power Windows

Driver's Window Motor Test

'99-02 models
Motor Test
1. Remove the driver's door panel (see page 20-7).
2. Disconnect the 4P connector from the window
motor.
Terminal side of male terminals
3. Test the motor in each direction by connecting
battery power and ground according to the table.
When the motor stops running, disconnect one
lead immediately.
Terminal
Direction
UP
DOWN
4. If the motor does not run or fails to run smoothly,
replace it.
Pulser Test
5. Connect the test leads of an analog ohmmeter to
the No. 3 and No. 4 terminals.
6. Run the motor by connecting power and ground to
the No. 1 and No. 2 terminals. The ohmmeter
needle should move back and forth alternately.
7. If the test is not as specified, replace the driver's
window motor.
22-212 22-212
1 2
'03-04 models
Motor Test
1. Remove the driver's door panel (see page 20-7).
2. Disconnect the 2P and 4P connectors from the
window motor.
3. Test the motor in each direction by connecting
battery power and ground according to the table.
When the motor stops running, disconnect one
lead immediatery.
Terminal
Direction
UP
DOWN
4. If the motor does not run or fails to run smoothly,
replace it.
A1 A2