To Delete a Master, Manager, or Operator Code
Enter [your code]* +[8] + [User number (02-75)] + [your code again]
* An Installer, Master, or Manager Code can be used instead of Installer Code. If used
instead of an Installer Code, it must have a higher level of authority than the code being
changed. For example, a Master Code can add a Manager or Operator-level Code, but cannot
add another Master Code; a Manager Code can add an Operator-level Code, but cannot add a
Master or another Manager Code.
OK TO DELETE 03?
0=NO
A user code can only be deleted from the partition through which it was entered. If trying to delete
from another partition, the message USER [XXX] NOT DELETED will be displayed.
To EXIT the User Edit Mode
Press either [ ] or [#], or don't press any key for 10 seconds.
The system will prompt to confirm that you want to delete this
user. Press 0 (NO) or 1 (YES).
1=YES
If yes, that user's code will be removed from all partitions to
which it was assigned, and all authorization levels and other
information about that user will be deleted. Note that a user
can only be deleted by a user with a higher authority level. A
user cannot delete himself/herself.
Section 28 – User Access Codes
28–7