Section 21 - Zone Type Definitions; Zone Number Designations; Zone Type Definitions - ADEMCO VISTA-32FB Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Zone Number Designations

Zone Type Definitions

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Zone Number Designations
The VISTA- 32FB supports up to 32 zones of hardwire, polling loop and/or wireless
protection, distributed among up to 2 partitions. The following table lists the zone numbers
and the types of sensors that can be used with each in this system, and some alternate
functions the zones may be used as:
Zone Type Definitions
Each zone must be assigned a zone type, which defines the way in which the system
responds to faults in that zone. In addition, there are three keypad-activated zones (panic
keys; see note) for each partition, a polling loop supervision zone, and four RF supervisory
zones, two for each RF receiver installed. Zone types are defined below.
Type 00: Zone Not Used
Program a zone with this zone type if the zone is not used.
Type 01: Entry/Exit #1 Burglary
This zone type provides entry delay whenever the zone is faulted if the control is armed in the AWAY or
STAY Mode. When the panel is armed in the INSTANT or MAXIMUM Mode, no entry delay is provided.
Exit delay begins whenever the control is armed, regardless of the arming mode selected. These delays are
programmable. This zone type is usually assigned to sensors or contacts on doors through which primary
entry and exit will take place.
Zone Sensors
1 and 2 2-wire Smoke Detectors (if used)
5 Audio Alarm Verification (if used)
6 Cabinet Tamper/Ground Fault (if used)
7 Keyswitch (if used)
8 Latching-Type Glassbreak Detectors (if used)
1-8 Traditional Hardwired Zones
1-32 5800 Series Wireless Devices
9-32 Polling Loop Devices
995 + 1 Panic
996 # + 3 Panic
999 + # Panic
Zone Type Definitions
S E C T I O N 2 1
21–1