Programming Event Log Options; Event Logging Procedures - ADEMCO VISTA-32FB Installation And Setup Manual

Programming Event Log Options

1. With at least one alpha keypad (6139/6139R) wired and set to a proper address,
temporarily apply power to the system.
2. Enter Data Field Programming Mode: [Installer Code] + [8 0 0].
3. Program the following data fields:
1 70 EVENT LOG TYPES (1=enable; 0=disable for each type)
1 71 12/24-HOUR TIME STAMP FORMAT (0=12 hr; 1=24 hr)
1 72 EVENT LOG PRINTER ON-LINE (0=disable; 1=enable)
1 73 PRINTER BAUD RATE (1=300; 0=1200)
4. Enter Report Code Programming in #93 Menu Mode (refer to the Quick Start Guide) to
program report codes for the event log (System Group #4 codes).
5. Exit Program Mode by pressing 99.
If you need more information about actual programming procedures, see Section 20: The
Mechanics of Programming.

Event Logging Procedures

In order for proper time and date stamping to occur, the system's real-time clock must be set.
Refer to Section 28: Setting the Real Time Clock .
If the printer is selected to be on-line (field 1 72), events will print automatically, as they
occur. To display or print on demand, the following commands apply:
Display/Printing: After entering either the Display or Print Mode, the following will be
displayed:
ENTER 0 = RECENT
1 = COMPLETE
Commands
Display Mode:
Print Mode:
Clear Event Log:
To EXIT Event Log:
The event log holds up to 224 events, and can display or print
all events in a category (complete), or only those events in a
category occurring since the last Clear Event Log command
(recent). Note that once the event log is full, the oldest event
will be erased upon the logging of any new event. Press the
desired Display Mode key, 0, or 1.
[Installer or Master Code] + [#] + [60]
[Installer or Master Code] + [#] + [61]
[Installer or Master Code] + [#] + [62]
Press at any time.
Section 17 – Event Log Options
17–3