4100Apg Led Indications - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide
•
In field 70 enter the Pager ID number of the paging service for Bypass reports. This is
the PIN number. Up to 10 digits may be entered.
•
In field 71 enter the phone number of the paging service for Open/Close reports. Up to
17 digits may be entered.
•
In field 72 enter the Pager ID number of the paging service for Open/Close reports. This
is the PIN number. Up to 10 digits may be entered.
•
In field 73 enter the phone number of the paging service for System reports. Up to 17
digits may be entered.
•
In field 74 enter the Pager ID number of the paging service for System reports. This is
the PIN number. Up to 10 digits may be entered.
•
In field 75 enter the phone number of the paging service for Test reports. Up to 17
digits may be entered.
•
In field 76 enter the Pager ID number of the paging service for Test reports. This is the
PIN number. Up to 10 digits may be entered.
•
In field 1 70 enable the events for the event log.
•
In field 1 72 enable the Printer On-Line option. This must be turned on to allow events
to be sent to the pager interface when they occur.
Field 3 19 MUST be programmed with a 1 in order for the printer and pager to operate properly.

4100APG LED Indications

Below is a table outlining the LED indications:
LED Name
Power
Line
Call
Busy
Page
Data
Load
TRBL
18–4
Steady
OK On Battery (B/U)
Not in use (OK)
Call in Progress
Telephone Busy No Dial Tone
Blinking
No Power
In Use
Page Retry
Page Fail
No Data
No Data
Trouble
Off Pulse
Idle
OK
OK Page OK
Msg Data
Prog Data
OK