ADEMCO VISTA-32FB Installation And Setup Manual page 122

VISTA-32FB Installation and Set-Up Guide
29 QUICK ARM (partition-specific)
Enter 1 to enable arming of the burglary system in AWAY, STAY, INSTANT, or
MAXIMUM modes by using the [#] key instead of the user code. When armed, the
system reports closing as User 0 if Open/Close reporting for User 2 (typically a Master
level user) was enabled for a given partition. Enter 0 if Quick Arm is not desired. (The
user code must always be used to disarm the system.) Note that if Quick Arm is used,
the Installer Code and Authority Level 5 codes cannot disarm the system.
30 MAIN DIALER (TOUCHTONE OR ROTARY DIAL)
Enter 1 if Touch-tone service is being used.
Enter 0 if rotary phone service is used.
If selecting TouchTone, make sure the subscriber has requested and is paying for Touch-tone
service. Note that whether or not Touch-tone dialing for call placement is permitted, communication
by the use of DTMF signaling (ADEMCO High Speed) will still take place. See field 1 33
TouchTone W/Rotary Backup.
31 PABX ACCESS CODE
This field is used to enter up to four 2-digit numbers 00-09; B-F (11-15). If not required,
enter nothing and proceed to next address; otherwise, enter prefix needed to obtain an
outside telco line.
32 PRIMARY SUBSCRIBER ACCT # (partition-specific)
Enter a 3- or 4-digit (depending on report format) primary subscriber account number
00-09; B-F (11-15). Each number requires a 2-digit entry so as to allow entry of
hexadecimal digits (B-F). If a 3-digit account number is to be used, enter data only in
the first 3 locations, leaving the last one unfilled, by entering a .
33 PRIMARY PHONE NUMBER
This field is used to enter the primary central station phone number, up to 17 digits, 0-
9; enter #11 for , #12 for #, and #13 for a 2-sec. pause. This is the phone number the
control will use to transmit alarm and status messages to the central station. Do not fill
unused spaces.
Note: Backup reporting is automatic only if a secondary phone number is entered, and
no dual/split options have been programmed (the number of attempts to the primary
number before dialing the secondary number is determined by field 3 21).
34 SECONDARY PHONE NUMBER
This field is used to enter the secondary phone number, up to 17 digits, 0-9; enter #11
for , #12 for #, and #13 for a 2-sec. pause. The secondary phone number is used if
communication on the primary number is unsuccessful, or if split/dual reporting is
desired. Do not fill unused spaces. If this field is programmed, a secondary subscriber
account number (field 90) must also be programmed (can be the same as the primary
account number).
23–4
Enter 00-09; B-F (11-15)
| | | | | | | | | | | | | | | |
| | | | | | | | | | | | | | | |
|
| |
|
| |
[15 15 15
[1]
[0]
|
|
15]