Figure 10-1: 4285/4286 Vip Module Connections - ADEMCO VISTA-32FB Installation And Setup Manual

CONTROL
PANEL
VIP MODULE
NOT INSTALLER
ADJUSTABLE
NOT USED
CONNECTOR
WITH FLYING
LEADS

Figure 10-1: 4285/4286 VIP Module Connections

1. Make all connections exactly as shown in Figure 10-1 . This is essential, even if the system is
not connected to a central station. The 4285/4286 will not function if this is not done. If the
leads on the cable are too short to reach their assigned terminals, splice additional wires to
them, as required.
2. If touch-tones are not present following phone access to the security system via an on-
premises phone, try reversing the wires connected to terminals 3 and 4 on the 4285/4286.
If the phone plug is disconnected from the control, the premises' phones will not operate.
RJ31X
JACK
8-CONDUCTOR
DOUBLE PLUG
CORD (SUPPLIED)
MAIN
JACK
DIALER
JACK
DIRECT
CONNECT
CORD
4285/4286
YELLOW: TO DATA OUT (term. 14)
NO CONNECTION
RED: TO AUX (+) (term. 11)
BLACK: TO AUX. GROUND (–) (term. 12)
GREEN: TO DATA IN (term. 13)
Section 10 – 4285/4286 VIP Module
INCOMING TELCO LINE
CALLER
ID UNIT
RJ31X
JACK
GRAY
1 - TIP
BROWN
2 - RING
RED
GREEN
3 - TIP
4 - RING
5 - NC
6 -
7 -
TO CONTROL
PANEL
TERMINALS
USED FOR
KEYPAD
CONNECTIONS
PREMISES
ANSWERING
MACHINE AND
PHONES
ANSWERING
MACHINE
4285/4286 VIP MODULE
TERMINAL ASSIGNMENTS
}
PHONE INPUT
}
PHONE OUTPUT
}
AUDIO OUT 1
(FOR FUTURE USE)
10–3