ADEMCO VISTA-32FB Installation And Setup Manual page 160

VISTA-32FB Installation and Set-Up Guide
ADVISORY: ADEMCO's Contact ID reporting is capable of uniquely reporting all 32 zones
of information, as well as openings and closings for all 75 users, to central stations equipped
with the ADEMCO 685 receiver using software level 4.4 or higher. Must be level 4.7 or
higher to fully support all new VISTA-32FB report codes. 685 software levels below 4.4
cannot support Contact ID reporting. If you need to update your 685 receiver, contact your
distributor.
The following describes each format in greater detail.
3+1 and 4+1 Standard
Formats
3+1 and 4+1 Expanded
Formats
4+2 Format
ADEMCO Contact ID
Reporting Format
ADEMCO High Speed
Report
Alarm
Trouble
Bypass
AC Loss
Low Batt
Open
Close
Test
25–2
Comprised of a 3- (or 4-) digit subscriber number and a single-
digit report code (e.g., Alarm, Trouble, Restore, Open, Close,
etc.).
Comprised of a 3- (or 4-) digit subscriber number and a two-
digit report code. The first digit is displayed on the first line,
followed by a second line where the first digit is repeated 3 (or
4) times and followed by the second digit. This is the
expanded digit.
Comprised of a 4-digit subscriber number and 2-digit report
code.
Comprised of a 4-digit subscriber number, 1-digit event
qualifier (new or restore), 3-digit event code, 2-digit partition
number, and 3-digit zone number, user number, or system
status number.
Comprised of 13 digits as follows: a 4-digit account number +
eight channels of zone information (1-8 or duress plus 9-15) +
one status channel, which identifies the type of events being
reported in the eight zone locations.
3+1/4+1
Standard
SSS(S) A
SSS(S) T
SSS(S) B
SSS(S) E
SSS(S) L
SSS(S) O
SSS(S) C
SSS(S) G
3+1/4+1
Expanded
SSS(S) A
AAA(A) Z
SSS(S) T
TTT(T) t
SSS(S) B
BBB(B) b
SSS(S) E
EEE(E) A C
SSS(S) L
LLL(L) L B
SSS(S) O
OOO(O) U
SSS(S) C
CCC(C) U
SSS(S) G
GGG(G)g
4+2
Low Spd or
Express
SSSS AZ
SSSS Tt
SSSS Bb
SSSS EA C
SSSS LL B
SSSS OU
SSSS CU
SSSS Gg