Loading Communication Defaults - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide
The status channel might have one of the following conditions:
1 = DURESS (for duress plus Channels 9-15 only)
2 = OPENING
3 = BYPASS (for channels 1-8 only)
4 = CLOSING
5 = SUPERVISORY/TROUBLE (for Channels 1-8 only)
6 = SYSTEM STATUS:
7 = NORMAL ALARM STATUS (Channels 1-8 Only)
9 = TEST REPORT
Explanation of Channels 9-15:
If there is a 1 in the status channel, and:
1 in the 1st location = Duress
1 in Channels 9-15 = Zone alarm on those channels
3 in Channels 9-15 = Restore on those channels
6 in Channels 9-15 = Previously reported alarm–not restored
A typical high-speed report may look like this:
1234 5115 5555 7 (Acct #1234 with alarms on Channels 2 and 3)
1234 5555 1555 1 (Acct #1234 with alarm on Channel 12)
Limitations
•
When using ADEMCO High-Speed, remember there are only 15 channels available, plus
a duress channel. If more than 15 zones are being used, they will have to share channels.
•
With ADEMCO High-Speed reporting, channels 9-15 cannot report troubles or bypasses.
Use these channels for zones that will not report these conditions.
•
Only user numbers 1-15 can be uniquely reported with Open/Close reports in ADEMCO
High-Speed.

Loading Communication Defaults

To help expedite the installation, the system provides 4 different communication defaults
(Low Speed, ADEMCO Express, ADEMCO High-Speed and ADEMCO's Contact ID).
You may load communications defaults at any time. However, it is recommended that the
panel be defaulted first ( 97) only if no other programming has been done. If other
programming has already been done, there is no need to default the panel.
25–4
• AC LOSS in Channel 1
• LOW BATTERY in Channel 2
• TIME SET in Channel 3
• LOG CLEAR in Channel 3
• LOG 50% FULL in Channel 3
• LOG 90% FULL in Channel 3
• LOG OVERFLOW in Channel 3
• POWER ON RESET in Channel 4
• WALK-TEST START, END in Channel 8