Entering Data Field Programming Mode; Moving From One Page Of Programming To Another; Viewing Data Fields - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide
The factory-loaded defaults ( 97) enable keypad addresses 00-01 only. A keypad set to one of
these addresses must be used to program the system.

Entering Data Field Programming Mode

Enter Program Mode using either method A or B:
A. Press both the [ ] and [#] keys at the same time within 30 seconds after power is
B. Enter the [Installer Code] + [8 0 0]. The factory installer code can be changed once
Local keypad programming can be disabled through Compass downloading software. If this is
done, programming can only be accomplished via the downloading software.

Moving from One Page of Programming to Another

The data fields are grouped into four levels (referred to as pages). The first page is accessed
as soon as Programming Mode is entered.
The second, third, and fourth pages of data fields are indicated at the keypad by a 1, 2, and 3,
respectively, in front of the 2-digit field address. The words ALT PROGRAM MODE are
displayed along with 100, 200, or 300, depending upon which page of program fields is
accessed, to indicate the higher page of fields.
1. To access the next level of fields, press 94.
2. Then press [ ] + [XX], where XX = the last two digits of the program field, and make the
desired entry.
3. To return to the previous page of fields, press 99.
press 94 to move to 2nd page; press 99 to move back to 1st page
press 94 to move to 3rd page;
press 94 to move to 4th page;

Viewing Data Fields

To view the contents of a data field, press [#] + [the 2-digit field address]. The field's
entries will be displayed, but no changes can be made.
20–2
applied to the control.
the Program Mode (field 00) has been entered.
second page of fields
(1 01-1 77)
press 99 to move back to 2nd page
third page of fields
(2 00-2 24)
press 99 to move back to 3rd page
fourth page of fields
(3 00-3 85)