ADEMCO VISTA-32FB Installation And Setup Manual page 156

VISTA-32FB Installation and Set-Up Guide
Mon DISARM WIND.
00:00AM 00:00AM
Mon ARM WINDOW
00:00AM 00:00AM
Tue DISARM WIND.
00:00AM 00:00AM
Days ? MTWTFSS
Hit 0-7
24–18
This prompt is for entering the start and end times of the
disarm (opening) window for Monday.
Upon entry of this mode, the cursor will be positioned on the
tens of hours digit of the start time of the disarm window.
Enter the desired hour.
Press [ ] to move to the minutes field. The minutes are
entered in the same manner.
Press [ ] to move to the AM/PM position. Pressing any key in
the 0-9 range will toggle the AM/PM indication.
Repeat the procedure for the stop time entry.
Press [ ] to store the entries and move to the arming (closing)
window for Monday.
Pressing [#] will scroll you through the prompts without
making any changes.
This prompt is for entering the start and end times of the arm
(closing) window for Monday.
The cursor will be positioned on the tens of hours digit of the
start time of the arm window. Enter the desired hour.
Press [ ] to move to the minutes field. The minutes are
entered in the same manner.
Press [ ] to move to the AM/PM position. Pressing any key in
the 0-9 range will toggle the AM/PM indication.
Repeat the procedure for the stop time entry.
After the windows for that day have been completed, the
system will prompt for disarm and arm time windows for the
next day.
Press [#] if no changes are desired.
Repeat the procedure described above for all days of the week.
When all the windows for all the days have been completed, the
system will prompt which days of the schedule are to be
activated.
This is the prompt that actually activates the temporary
schedule.
x x
To select the days that are to be activated, enter 1-7 (Monday
= 1). An "x" will appear under that day, indicating the
temporary schedule for that day is active. Entering a day's
number again will deactivate that day. Pressing 0 will toggle
all days on/off.
The temporary schedule will only be in effect for the days that
have the letter "x" under them. As the week progresses, the
selected days are reset to the inactive state, but all other
entries for the temporary schedule will remain programmed.
Press [ ] to store the entries or press [#] to exit the Temporary
Schedule Entry Mode without making any changes.