Common Characteristics Of Hardwired Zones 1-8; Wiring Burglary And Panic Devices To Zones 1-8; Section 6 - Basic Hardwired Zones 001-008 - ADEMCO VISTA-32FB Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

Common Characteristics of Hardwired Zones 1-8

Wiring Burglary and Panic Devices to Zones 1-8

Wiring 2-Wire Smoke Detectors to Zones 1 and 2
Compatible 2-Wire Smoke Detectors
Wiring 4-Wire Smoke Detectors to Zones 1-8
Compatible 4-Wire Smoke Detectors
Fire Alarm Verification for Smoke Detectors
Zone 6 Tamper Configuration
Wiring 2-Wire Latching Glassbreak Detectors to Zone 8
Compatible Glassbreak Detectors
Programming Hardwired Zones
Checkout Procedure for Hardwired Zones
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
Common Characteristics of Hardwired Zones 1-8
•
EOLR supervision (optional for zones 3-8) supporting N.O. or N.C. sensors (EOLR
supervision required for fire and UL Burglary installations).
•
Can be individually assigned to either of two partitions.
•
Up to 16 2-wire smoke detectors each on zones 1 and 2 (32 total).
•
4-wire smoke or heat detectors on zones 1-8 (power to 4-wire smoke detectors must be
supervised with an EOL device).
•
Up to 50 2-wire latching glassbreak detectors on zone 8.
•
Can be individually assigned to bell outputs and/or aux. relay.
Wiring Burglary and Panic Devices to Zones 1-8
1. Connect sensors/contacts to the hardwire zone terminals (15 through 27).
2. Connect N.C. devices in series with the high (+) side of the loop. The 2K EOL resistor
must be connected in series with the devices, following the last device.
3. Connect N.O. devices in parallel (across) the loop. The 2K EOL resistor must be
connected across the loop wires at the last device.
Basic Hardwired Zones 001-008
S E C T I O N
6–1
6