ADEMCO VISTA-32FB Installation And Setup Manual page 136

VISTA-32FB Installation and Set-Up Guide
3 12 ZN TYPE 18 DELAY USE
Enter 0 if there is to be no delay for zone type 18.
Enter 1 to use delay set in field 3 16 for zone type 18.
Note: For UL Listed installations, combined initiating device's delay and this field's
delay cannot exceed 90 seconds.
3 13 SUPERVISORY ON OPEN and SHORT
Enter 0 if you want a supervisory response on a shorted zone and a trouble response on
an open zone. Enter 1 if you want a supervisory response on either a shorted or an open
zone.
3 14 WATERFLOW ALARM SILENCE OPTION
Enter 0 if you want waterflow supervisory zones to be silenced by entering the [Code] +
[OFF]. Enter 1 if you want waterflow supervisory zones to silence automatically when
waterflow ceases. This feature may only be set to 1 by permission of the local authority.
3 15 ALARM SOUNDS BELL 1, 2
Enter 0 for pulsing, 1 for steady output on Bell Outputs 1 and 2. If pulsing is selected,
field 08 applies.
3 16 ZONE TYPES 17 and 18 DELAY
Enter 01-15 times 2 seconds if a delay is desired for waterflow and fire supervisory
zones. This may help prevent alarms due to minor fluctuations in waterflow.
Otherwise, enter 00.
3 17 ZONE 6 ALTERNATE FUNCTION ENABLE
Enter 1 to enable Zone 6 as a tamper zone (Bell Tamper).
3 18 EXTENDED DELAY FOR TYPES 17 and 18
This option allows the delay programmed in field 3 16 for waterflow and fire
supervisory zones to be extended by 4 times.
Enter 1 to multiply delay by 4.
Enter 0 to use delay programmed in field 3 16.
For a waterflow alarm, total maximum allowable time delay (device and panel) is 90 seconds.
U L
For a supervisory signal, total maximum allowable time delay (device and panel) is 200 seconds.
3 19 AUXILIARY INPUT ALTERNATE FUNCTION ENABLE
Enter 1 to enable pins 5 and 9 as printer RXD and DTR. Enter 0 if pins are to function
as selected in 3 20.
23–18
[1]
[0]
[0]
[1,0]
Bell 1 Bell 2
[00]
|
[0]
[0]
[0]