ADEMCO VISTA-32FB Installation And Setup Manual page 179

† Master or Manager Code can be used instead of Installer Code. If used instead of an
Installer Code, it must have a higher level of authority than the code being changed. For
example, a Master Code can add a Manager or Operator-level Code, but cannot add another
Master Code; a Manager Code can add an Operator-level Code, but cannot add a Master or
another Manager Code.
Keypad will prompt for the authority level for this user.
User Number = 03
Enter Auth. Level
Open/Close Rep.?
0 = NO , 1 = YES
Access Group?
Enter 0-8
RF Button ?
0=NO , 1=YES
Enter Button ZN #
(001-032)
Multi-Access ?
0 = NO , 1 = YES
Global Arm ?
0 = NO , 1 = YES
Enter the level number as follows:
1 = Master (arm, disarm, bypass, add, or modify lower-level
users)
2 = Manager (arm, disarm, bypass, add, or modify lower-level
users)
3 = Operator Level A (arm, disarm, bypass)
4 = Operator Level B (arm, disarm)
5 = Operator Level C (arm, disarm only if system armed with
this code)
6 = Duress (arm, disarm, trigger silent panic alarm)
Keypad will then prompt for Open/Close reporting option for this
user.
Press 0 (NO) or 1 (YES), depending on whether or not
arming/disarming by this user will trigger Opening and Closing
reports. This prompt appears only if the Installer Code is used
to add a user.
If access schedules have been programmed, this prompt
appears. Enter the user's access group number (1-8) if this user
should have limited access to the system. Enter 0 if no access
group should be assigned.
If a 5800 Series button transmitter has been enabled for
arming/disarming functions, and is not assigned to a user, this
prompt will appear. Press 0 (NO) or 1 (YES).
If the answer to the RF button question is yes, the zone number
for the button will be requested. Enter any one of the zone
numbers assigned to the button transmitter as AWAY, STAY,
or DISARM. The system will then assign all buttons of the
transmitter to this user number.
Press 0 (NO) if the user is to have access to this partition only.
Press 1 (YES) if the user is to have access to more than one
partition. If NO, the program exits this mode. If YES, the
keypad prompts for the Global Arm option for this user.
Press 0 (NO) or 1 (YES), depending on whether the user will be
allowed to arm more than one partition via Global Arm
prompts (described in Section 30: Keypad Functions) .
The keypad now prompts for the user's access to the next
Section 28 – User Access Codes
28–5