ADEMCO VISTA-32FB Installation And Setup Manual page 104

VISTA-32FB Installation and Set-Up Guide
2. Enter devices used
on Aux. Power 2
output, calculate
standby and alarm
currents, then add
to get Aux. Power 2
current subtotal.
3. Enter devices
connected to Bell 1
output, calculate
alarm currents,
then add to get Bell
1 output current
subtotal.
4. Enter devices
connected to Bell 2
output, calculate
alarm currents,
then add to get Bell
2 output current
subtotal.
5. Enter the total
polling loop current
using values
calculated in the
polling loop
worksheet.
19–4
AUX. POWER 2 OUTPUT
Device Model # Device Current X
BELL 1 OUTPUT
Device Model # Device Current X
Bell 1 Output Subtotal (terminals 3 & 4) 1.7 amp max
BELL 2 OUTPUT
Device Model # Device Current X
Bell 2 Output Subtotal (terminals 5 & 6) 1.7 amp max
Polling Loop
(Enter worksheet total, both standby & alarm columns)
# of Units
Aux. Power 2 Output Subtotal
(connector J4-pin 5)
# of Units
# of Units
Polling Loop Subtotal
Total Current
= Standby Alarm
400mA max 400mA max
Total Current
= Standby Alarm
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
Total Current
= Standby Alarm
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
XXXXXX
Total Current
Standby Alarm