ADEMCO VISTA-32FB Installation And Setup Manual page 135

2 18 ENABLE GOTO FOR THIS PARTITION (partition-specific)
Enter 1 if this partition is to be accessed from another partition's keypad using the
GOTO command. Otherwise enter 0.
2 19 USE PARTITION DESCRIPTOR
Enter 1 if partition descriptors will be programmed. If enabled, the normal keypad
display will include a partition number and four-digit descriptor.
Enter 0 to cause the keypads to display a nonpartitioned system type of display (no
partition number will appear).
2 20 ENABLE J2 TRIGGERS FOR PARTITION (partition-specific)
2 21 SUPERVISION PULSES FOR LRR
Used for supervised connection to 7920SE.
Enter 1 to enable pulses for each type of LRR trigger (Fire, Burglary, silent Panic,
Supervisory, Trouble). This option causes the control to send periodic short pulses on
the J2 radio triggers. These pulses are used by the 7920SE to determine that its
connection to the control is still intact.
Enter 0 if not desired.
Must be 1 for commercial fire and UL.
2 22 DISPLAY FIRE ALARMS OF OTHER PARTITIONS (partition-specific)
Enter 1 to allow fire alarms that occur on other partitions to be displayed at this
partition's keypad(s). Otherwise, enter 0.
2 23 DISPLAY BURG and PANIC ALARMS OF OTHER PARTITIONS
Enter 1 to allow burglary and panic alarms that occur on other partitions to be
displayed at this partition's keypad(s). Otherwise, enter 0.
2 24 DISPLAY TROUBLES OF OTHER PARTITIONS
Enter 1 to allow troubles that occur on other partitions to be displayed at this partition's
keypad(s). Otherwise, enter 0.
3 00 CHECK OR TRBL DISPLAY
Enter 1 to display the letters TRBL instead of CHECK when a zone or system trouble
occurs.
Enter 0 to display CHECK.
3 01 FIRE DISPLAY LOCK
Enter 0 to scroll all alarms.
Enter 1 to lock display of first fire alarm (press
Section 23 – Data Field Descriptions
[00000]
F
to display other alarms).
[0]
[0]
[1]
| | | |
B P S T
[0]
[0]
[0]
[0]
[0]
23–17