User Scheduling Menu Mode - ADEMCO VISTA-32FB Installation And Setup Manual

User Scheduling Menu Mode

The system provides up to 20 timers that will be available to the end user for the purpose of
controlling output devices (4204 relay). These timers are comparable to the individual
appliance timers that might be purchased at a department store. The output devices
themselves are programmed into the system by the installer during Relay Programming in
#93 Menu Mode (refer to the Quick Start Guide). The end user needs only to know the
output device number and its alpha descriptor.
The installer may set certain relays to be restricted during Relay Programming in #93 Menu
Mode (refer to the Quick Start Guide). These relays may not be controlled by the end user
(this prevents the end user from controlling doors, pumps, bell outputs, etc.).
To enter this mode, the user enters [Security Code] + [#] + [83].
Output Timer # ?
01-20, 00=Quit 01
06 07:00P 11:45P
PORCH LITE
06 ENTER OUTPUT#
PORCH LITE
Entering 00 as the output number deletes the timer (Timer 06, in this example) and displays an
output descriptor of None. Output devices are programmed via # 93 Menu Mode (refer to the
Quick Start Guide).
06 ON TIME ?
07:00 PM
06 OFF TIME ?
Enter the output timer number to be programmed (01-20).
Press [ ] to accept entry and move to the next prompt.
Enter 00 to quit and return to normal operating mode.
If that timer number has already been programmed, a
summary screen will appear. In this example:
04
Press [ ] to continue.
Enter the desired output number (01-16).
As the number is entered, the descriptor for that output device
04
will be displayed.
Press [ ] to continue.
The cursor will be positioned on the tens of hours digit of the
ON time. Enter the desired hour.
Press [ ] to move to the minutes field. The minutes are
entered in the same manner.
Hitting any key in the 0-9 range while the cursor is under the
AM/PM position toggles the AM/PM indication.
Press [ ] to continue.
The cursor will be positioned on the tens of hours digit of the
OFF time. Enter the desired hour.
11:45 PM
Press [ ] to move to the minutes field. The minutes are
06 = Timer #
07:00PM = Start Time
11:45PM = Stop Time
PORCH LITE = Descriptor for Output Device # 4
04 = Output Device # affected by this timer
Section 24 – Scheduling Options
24–19