To Change A Master, Manager, Or Operator Code; To Add An Rf Key To An Existing User - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide
Part. 2 – SHOP ?
0 = NO , 1 = YES
Part. 1 A0
User 03 Auth=3G.

To CHANGE a Master, Manager, or Operator Code

Enter [Installer code]* + [8] + [User number (02-75)] + [new user's code]
* An Installer, Master, or Manager Code can be used instead of Installer Code. If used
instead of an Installer Code, it must have a higher level of authority than the code being
changed. For example, a Master Code can add a Manager or Operator-level Code, but cannot
add another Master Code; a Manager Code can add an Operator-level Code, but cannot add a
Master or another Manager Code.
User Number = 03
NEW USER?

To Add an RF Key to an Existing User

To add an RF key to an existing user, or to change a user's global arm option, first delete that
user's code, then re-add the user code as described in the To ADD a Master, Manager, or
Operator Code paragraph.
28–6
partition.
Press 0 (NO) or 1 (YES), depending on whether this user will
have access to the displayed partition number. If NO, the
keypad displays this prompt for the next partition number in
sequence.
If YES, the keypad prompts for the following:
•
User's authority level in the displayed partition (see
Authority Level prompt above).
•
Open/Close option for this user in the displayed partition
(see Open/Close prompt above).
•
Global Arm option for this user in the displayed partition.
When all partitions have been displayed, the keypad will scroll
through all partitions to which access has been assigned, and
will display the user number, authority level, open/close and
global arm options that were programmed for each partition to
which the user was granted access.
Note that the G following the authority level indicates that the
WHSE
Global Arm feature is enabled for this user in the displayed
partition, and that the period at the end of the second line
indicates Open/Close reporting is enabled for this user in the
displayed partition. The
the user may be changed or deleted.
The system detects that the user number is already assigned,
and will prompt if this is a new user.
Press 0 (NO).
The system will then confirm that the change is allowed based
on authorization level.
indicates the partition from which