Arming Functions - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide

Arming Functions

The following is a brief list of system commands. For detailed information concerning system
functions, refer to the User's Manual.
Display Faulted
Zones
Arming Away
Arming Stay
Arming Instant
Arming
Maximum
Disarming
Bypassing Zones
Chime Mode
Quick Arming
A user code other than the Installer Code must be programmed into the system in order for the
Quick Arm feature to work.
Mode
AWAY
STAY
INSTANT
MAXIMUM
29–2
Before arming, the system must be in the READY condition (all
zones must be intact). If the NOT READY message appears, press
the READY key to display faulted zones.
Enter code + 2 (AWAY)
Enter code + 3 (STAY) (all zones designated as zone types 4 and 10
will be automatically bypassed).
Enter code + 7 (INSTANT) (same as STAY without entry delay).
Enter code + 4 (MAXIMUM) (same as AWAY without entry delay).
Enter code + 1 (OFF).
Enter code + 6 (BYPASS) + 3-digit zone number. To automatically
bypass all faulted zones, use Quick Bypass method: [Enter code] +
[BYPASS] + [#].
Enter code + 9 (CHIME). To turn Chime Mode off, [Enter code] +
[CHIME] again.
Note that if QUICK ARM is enabled (field 29), the # key can be
pressed instead of entering the security code, for any of the arming
procedures (Away, Stay, Instant, Maximum, etc.).
SUMMARY OF ARMING MODES
Features for Each Arming Mode
Exit Delay Entry Delay
Yes Yes
Yes Yes
Yes No
Yes No
Perimeter Armed Interior Armed
Yes Yes
Yes No
Yes No
Yes Yes