Section 27 - Setting The Real-Time Clock; General Information; Setting The Time And Date - ADEMCO VISTA-32FB Installation And Setup Manual

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
In This Section

General Information

Setting the Time and Date

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
General Information
This system provides a real-time clock, which must be set in order for the system's event log
to keep track of events by time and date. It must also be set in order to execute scheduling
programs (time-driven events).
Use a 6139 Alpha Keypad to set the real-time clock, or set the clock via the downloader software.
Only users with Installer or Master authority level can set the real-time clock.
Setting the Time and Date
1. Enter [Installer or Master Code] + [#] + [63]. Typical display shows:
2. The day of the week is automatically calculated based on the date entered. Time and
date entries are made by simply entering the appropriate hour, minute, month, day, and
year.
•
•
•
•
•
•
•
3. Exit Clock Mode by pressing [ ] after the cursor is in the year position.
Setting the Real-Time Clock
Press [ ] to accept the entered value. The cursor then moves to the right.
Press [#] to move the cursor to the left of the display, to the previous position.
Enter the correct hour. Then press [ ] to move to the minutes field and make the
correct entry.
Press [ ] again, then press any key 0-9 to set AM/PM. Press any key again to change
AM to PM, or PM to AM.
Press [ ] to move cursor to the month field position and enter the correct month
using a 2-digit entry.
Press [ ] and enter the correct date.
Press [ ] and enter the correct year.
TIME/DATE –– THU
12:01 AM 01/01/90
S E C T I O N 2 7
27–1