Time Windows - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide

Time Windows

The system provides 20 time windows that are defined with start and stop times. These
windows are used for various open/close and access schedules, as well as for output controls,
and are the basis of the scheduling system. These windows are shared among all 2 partitions.
Time Windows Worksheet
The following worksheet will help you define time windows and scheduling aspects of this
system before programming the time window definitions for this installation. Note that time
windows can span midnight.
Time Window
Number
3.....20
A time window must have a start and a stop time.
Time Windows Programming
Enter Scheduling Mode by entering [Installer Code + [#] + [80]. The keypad will display
the TIME WINDOW prompt.
Time Window ?
1 Yes
Time Window # ?
01-20, 00 = Quit 01
01 TIME WINDOW
00:00AM 00:00AM
Quit ?
1 = YES 0 = NO 0
Since the time windows are shared among all partitions, it is important to make sure that
changing a time window does not adversely affect desired actions in other partitions.
24–8
1
2
Enter 1 at this main menu prompt to program time windows.
0 = No 0
Enter the 2-digit time window number (01-20) to be
programmed.
Press [ ] to accept the entry.
Enter 00 + [ ] at the TIME WINDOW #? prompt to quit time
window programming and display the QUIT ? prompt.
If a time window number was entered, the cursor will be
positioned on the tens of hours digit of the start of window
entry.
Enter the desired start of window hour and press [ ]. The
cursor will move to the minutes. Enter the desired minutes
and press [ ]. Toggle the AM/PM indication by pressing any
key 0-9 while the cursor is under the A/P position and then
press [ ]. Repeat this to program the stop of window entry.
When the entry is completed, the TIME WINDOW #? prompt is
displayed again.
Enter the next time window number to be programmed and
repeat the procedure.
Enter 0 at the QUIT ? prompt to return to the main menu
choices and continue programming.
Enter 1 to quit Scheduling Menu Mode.
Start Time
(HH:MM)
Stop Time
(HH:MM)