Manual Relay Activation Mode (#70 Mode) - ADEMCO VISTA-32FB Installation And Setup Manual

VISTA-32FB Installation and Set-Up Guide
Note that the D key is pressed after each command. Press D twice to complete the entry and
exit.
When defining Speed Key sequences, do not use the [#] key to represent Quick Arming. The
system uses the code entered in response to the prompt to initiate commands in a Speed Key
sequence, so the Quick Arm key is unnecessary. The system interprets the use of the [#] key in
a Speed Key sequence as its designated function only (e.g. 2 is not interpreted as Arm-AWAY,
but rather as Enter House ID Sniffer Mode).
Executing Speed Key Sequence
To execute a Speed Key sequence, do the following:
If a lettered key, A-B-C, has been assigned as a Speed Key, press the appropriate key. If a
user code is required for any part of the Speed Key sequence, the following prompt appears.
Otherwise, the Speed Key sequence automatically begins.
ENTER USER CODE
Enter the user code. The programmed Speed Key sequence will begin automatically.
To activate a Speed Key not assigned to the A-B-C keys, press and hold down the [D] key for
2 seconds until the following prompt appears:
ENTER SPEED KEY #
01-32
Enter the desired Speed Key number.
If a user code is required for any part of the Speed Key sequence, the following prompt
appears. Otherwise, the Speed Key sequence automatically begins.
ENTER USER CODE
Enter the user code. The programmed Speed Key sequence will begin automatically.
The system will apply the user code's Global Arming capabilities if the macro executes any
arming or disarming commands.

Manual Relay Activation Mode (#70 Mode)

The system allows users to manually activate relays by keypad command using either the
keypad or a telephone keypad (if VIP Module is used). The user will be prompted (either by
keypad alpha display or telephone voice module).
To activate relays from a keypad, enter 4-digit [Security Code] + [#70].
To activate relays using a telephone and VIP Module, first dial the 2-digit phone access code.
When the system acknowledges the access, enter 4-digit [Security Code] + [#70]. The
following prompts/voice responses will begin.
ENTER DEVICE NO.
00=QUIT
29–6
00=QUIT
Voice: ENTER DEVICE CODE NOW
Enter the 2-digit number of the relay to be activated.
01