Wiring Bell Outputs; Compatible Alarm-Indicating Devices - ADEMCO VISTA-32FB Installation And Setup Manual

Fire and burglary partitioned security system with scheduling
Table of Contents

Advertisement

VISTA-32FB Installation and Set-Up Guide
Program Zones 970 (Bell 1) and 971 (Bell 2) for 24-Hr. Trouble response (zone type 19)
(see Zone Programming in #93 Menu Mode Programming section of the Quick Start
Guide).
To unsupervise bell circuits, do the following:
Cut the white jumpers W1 (for Bell 1) and/or W4 (for Bell 2) on the main PCB.
Program zones 970 (Bell 1) and 971 (Bell 2) for a response type of 00 to disable
supervision (see Zone Programming in #93 Menu Mode Programming section of the
Quick Start Guide).
Do not install the EOL resistor(s) across the unsupervised output(s).

Wiring Bell Outputs

By default, Bell 1 is set to operate as an unsupervised burglary bell output. Any UL Listed,
nonpolarized burglary-indicating device rated for 10-14 VDC operation on this output can be
used. Note that a local burglary Grade A listing requires that a bell in a tamper-protected
housing be used (such as ADEMCO AB12) and that bell wiring be run in conduit.
By default, Bell 2 is set to operate as a supervised fire bell output. Note that the panel
supervises this wiring for open, short, and earth ground faults. Any UL Listed, polarized
fire-indicating device rated for 10-14 VDC operation may be used on this output. Observe
polarity when wiring polarized devices.

Compatible Alarm-Indicating Devices

Compatible devices are listed below. The wiring connections follow this chart.
14–2
Model
System Sensor PA400B
(beige)/PA400R (red)
System Sensor MA-12/24
System Sensor SS1215 ADA
System Sensor SS121575 ADA
System Sensor MASS1215 ADA
System Sensor MASS121575 ADA
System Sensor MA/SS-12
Wheelock LS1-12-VFR
Wheelock MS1-12-VFR
Wheelock MT-12-LS-VFR
Wheelock MT4-12-LS-VFR
Wheelock MT-12-MS-VFR
Wheelock MT4-12-MS-VFR
Gentex GXS-2-15
Gentex GXS-2-1575
Gentex SHG-12-15
Gentex SHG-12-1575
Faraday 5336L-U-14-12-DC
Faraday 5337L-U-14-12-DC
Description
Indoor piezo sounder (red or beige), rated
at 90 dB @ 10 feet.
Horn
Strobe
Strobe
Horn/Strobe
Horn/Strobe
Horn/Strobe
Strobe
Strobe
Horn/Strobe
Horn/Strobe
Horn/Strobe
Horn/Strobe
Strobe
Strobe
Horn/Strobe
Horn/Strobe
Horn/Strobe
Horn/Strobe

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents