ADEMCO VISTA-32FB Installation And Setup Manual page 151

3) Enter the desired activation time, which refers to when the action is to take place
relative to the time window. Select from:
Activation
Time-Driven Event Programming
The following schedules can be used to activate outputs, bypass zones, arm/disarm the
system, etc. based on a time schedule. Up to 20 events can be programmed for the system.
Time windows must first be defined in order to be used to trigger events.
If using time-driven events to control relays, the following menu items must first
be programmed using Relay Programming in the #93 Menu Mode (refer to the
Quick Start Guide):
Enter Relay No.
Relay Group
Restriction
Relay Type
ECP Address
Relay No. if 4204 relays
After entering Scheduling Menu Mode, press 0 until the TIMED EVENTS? prompt appears.
Timed Events ?
1 Yes 0 = No
TIMED EVENT # ?
01-20, 00=Quit 01
Description
time
1 Beginning of time window
2 End of time window
3 During time window active period only (i.e., on at
beginning of window, off at end). This can be used
in conjunction with the arm, disarm or bypass
commands to control a part of the system during
the window.
For example, if bypass is selected to activate during
the window, the zones in the zone list will be
bypassed at the beginning of the window and
unbypassed at the end of the window.
4 Beginning and end of time window (e.g., a Coffee
break buzzer). In this example, if relay pulse is
selected, the relay will pulse for 2 seconds at the
beginning of the window, signaling the beginning of
the coffee break. At the end of the window it will
pulse again, signaling the end of coffee break.
(reference identification number)
(if applicable)
(4204 or none)
Enter 1 to program timed events.
0
Enter the timed event number to be programmed (01-20).
Press [ ].
The system will then prompt the user to enter the desired action
to be taken.
Enter 00 at the TIMED EVENT #? prompt to quit the timed event
menus and display the QUIT ? prompt.
Section 24 – Scheduling Options
24–13