Securi~~Des; Master Code; User Codes; Generai Information - ADEMCO via30 Installation Instructions Manual

SECURITY CODES
Master Code The installer programs the 4-digit Master Code initially as part of the programming
procedure (see W?OGRAIMWVG THE SYSTEM). The factory default Master code W
is "4111".
The Master code can permit re-entry into the programming mode and also, in
normal operation mode, is used to enter the user codes, which also allow access
to the normal functions of the system.
See the Pl?OGRA/14M//VG section for information on exiting the programming
mode via fields '98 or '99.
User Codes In normal operation mode, the Master security code can be used to assign up to
three secondary security codes. It can also be used to remove secondary codes
from the system (individually).
To assign (or change) a Secondary security code, enter:
Master Code + [CODE key]+ User # (2 or 3 or 4) + desired Secondary Code
The system will emit a single beep when each secondary code has been suc-
cessfully entered.
To delete a Secondary security code, enter:
Master Code + [CODE key]+ User # (2 or 3 or
4)
Notes:
s All Master and Secondary security codes permit access to the system for arm-
ing, disarming, etc.
If a secondary code is inadvertently repeated for different users, or one user's
code is another's duress code (4th digit increased by
1), the lower
user number
will take priority.
Opening and closing reports are sent for the Master code as No. 1. User codes
are sent as Nos. 2, 3, and 4 respectively.
KEYPAD FUNCTIONS
General Information
Note that if QUICK ARM is enabled (field '21), the [#] key can be pressed instead
of entering the security code, for any of the arming procedures (Away, Stay, in-
stant, Maximum, etc.).The security code is a/ways required, however, when dis-
arming the system.
The keypad allows the user to arm and disarm the system, and perform other sys-
tem functions, such as bypassing zones, and display zone descriptors. Zone and
system conditions (alarm, trouble, bypass) are displayed in the Display Window.
When an alarm occurs, console sounding and external sounding will occur, and
the zone(s) in alarm will be displayed on the console. Pressing any key will silence
the console sounder for 10 seconds. Disarming the system will silence both con-
sole and external sounders. When the system is disarmed, any zones that were
in an alarm condition during the armed period will be displayed (memory of alarm).
To clear this display, simply repeat the disarm sequence (enter the security code
and press the OFF key) twice.
The consoles also feature chime annunciation, and 3 panic key pairs (for silent,
audible, fire or personal emergency alarms) which can notify the central station of
an alarm condition, if that service is connected.
–18–