Opening Vantage Report In Vantage Cnm - ZyXEL Communications VANTAGE CNM - V3.1 User Manual

2 Click CNM System Setting > VRPT Management > Add. Configure the Vantage
Report instance in Vantage CNM, and select the devices that should send log messages
to the Vantage Report instance. See
When you click Apply, Vantage CNM automatically configures the selected devices to
send log messages to the specified Vantage Report instance. It does not change any
settings for log categories or traffic statistics.
3 Click CNM System Setting > Configuration > Log Setting for each device. Make sure
the desired log categories are selected and that traffic statistics are sent to the Vantage
Report server. Refer to Vantage Report 3.1 User's Guide for more information.

21.4 Opening Vantage Report in Vantage CNM

After you set up a Vantage Report in Vantage CNM (see
device that is managed by Vantage Report, and click Log & Report > VRPT. Then you can
see the device's relative reports displayed via Vantage Report in the Vantage CNM as shown
next. Refer to Vantage Report User's Guide for more detailed information.
Figure 198 Log & Report > VRPT (Vantage Report Main Screen)
If the device is not managed by any Vantage Report instance yet, the Vantage Report window
does not open, an error message appears to say this device is not associated with the Vantage
Report.
Refer to Vantage Report User's Guide for more detailed information.
Vantage CNM User's Guide
Section 22.6 on page 337.
Section 21.3 on page
Chapter 21 VRPT
324), select a
325